Fuel Injection Cleaner
MANUFACTURED TO BS EN ISO 9002 SPECIFICATIONS
What it Does
Cleans injectors and injector nozzles, thereby improving the atomisation and spray pattern of the injected fuel. The product thus improves combustion and fuel efficiency. Test results below show fuel flow rates through a set of partially blocked injectors during the cleanup cycle, using the 
Fuel Injector Cleaner formulation.
a) INJECTOR TYPE: ROVER 216
b) MINIMUM FLOW RATE REQUIRED: 50ml /16 seconds @ 2.5 bar (New Part Spec. = 58ml/16secs. @ 2.5 bar)
| FLOW RATE IN 16 SECS MEASURED @ 2.5 BARS. | ||||
| INJECTOR No. |
SUBSTANDARD START |
AFTER 2 minutes |
AFTER 4 minutes |
AFTER 15 minutes |
| 1 | 35ml | 48ml | 48ml | 52ml |
| 2 | 37ml | 48ml | 48ml | 50ml |
| 3 | 45ml | 51ml | 52ml | 54ml |
| 4 | 35ml | 43ml | 45ml | 48ml |
| Totals | 152ml | 190ml | 193ml | 204ml |
| Averages | 38ml | 47.5ml | 48.3ml | 51ml |
When used regularly, (2 or more times per year) the composition of Fuel Injector Cleaner helps reduce any moisture build up around injectors, helps clean away upper cylinder deposits and deposits on valves and valve stems and prevent partial blocking of injectors as shown in above table. Additionally, Fuel Injector Cleaner will reduce upper cylinder wear and reduce deposits on catalytic converters. Often it will eliminate the characteristic rotten egg smell associated with deposits on catalytic exhaust converters. The product will also be effective in carburettors.
What it is
Fuel Injector Cleaner is a multi-functional Injector cleaner, which benefits the petrol engine. The formulation has been tried and tested, all over the world, for more than 10 years, but is regularly subjected to technical updates. The technology behind the active ingredients are sourced from the United States of America and the final formulation is arguably the most effective of its type available in the world today. The product will not damage catalytic exhaust converters.
How to use it
Where it is required to cure an existing problem relating to suspected injector fouling, Fuel Injector Cleaner is best fed directly into the injector rail from Flo-tec Injector Cleaning equipment or air powered equipment, available from various companies. This takes only about 20 minutes and results similar to the table above, can be expected. It is recommended that a fuel filter be placed in line between cleaning equipment and fuel rail.